power-control-board.h

Go to the documentation of this file.

/*
 * Copyright (c) 2014, Eistec AB.
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 * 3. Neither the name of the copyright holder nor the names of its contributors
 *    may be used to endorse or promote products derived from this software
 *    without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
 * AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
 * ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE
 * LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
 * POSSIBILITY OF SUCH DAMAGE.
 *
 * This file is part of the Mulle platform port of the Contiki operating system.
 *
 */

/**
 * \file
 *         Power control pins for the on board power switches on the Mulle board.
 *
 * \author
 *         Joakim Gebart <joakim.gebart@eistec.se>
 *
 */

#ifndef POWER_CONTROL_BOARD_H_
#define POWER_CONTROL_BOARD_H_

#include "K60.h"

#ifdef __cplusplus
extern "C" {
#endif

/*
 * Hardware dependent defines below.
 */
/* Update these if the hardware pins are swapped or moved */

/* The number of the GPIO function on the pins in the IO mux */
/* See Pin multiplexing in K60 reference manual */
#define POWER_CONTROL_GPIO_MUX_NUMBER 1

/* Pin numbers within the port */
#define POWER_CONTROL_VPERIPH_PIN_NUMBER 7
#define POWER_CONTROL_VSEC_PIN_NUMBER 16
#define POWER_CONTROL_AVDD_PIN_NUMBER 17

/* Port register for each pin */
#define POWER_CONTROL_VPERIPH_PORT PORTD
#define POWER_CONTROL_VSEC_PORT PORTB
#define POWER_CONTROL_AVDD_PORT PORTB

#define POWER_CONTROL_VPERIPH_GPIO PTD
#define POWER_CONTROL_VSEC_GPIO PTB
#define POWER_CONTROL_AVDD_GPIO PTB

#ifdef __cplusplus
} /* extern "C" */
#endif

#endif